Quote:
|
Quote:
I have an Acrylic Perspex rear window in my 250 GTO and have not had any heat related problems. The downside of Perspex is that it scratches a lot easier than Lexan. Neil |
Hi Ace,
Great looking build! I'm following with interest! Having had a good look at options today on my own SWB build I wondered whether you could please share your thoughts on fuel pipe connection between filler and tank please? I'm looking at the same position for the filler on mine and wondered if you've come up with a good routing plan? Many thanks in advance! |
Quote:
I can take some pictures showing what I have done, but I found a good route where the filler line is level and does not have any petrol sitting in the line after fill up. You run a 90 degree bend out of the tank connection and connect that up to a flexible fuel filler hose. I ran that over the arch of the wheel and then put another 90 degree bend that runs into the boot area. Then you have to run a solid 37" piece of 2" pipe across the top of the boot area where you can 90 into the fuel filler cap. That probably doesn't make sense, but I will take some pictures this evening and share them to give you an idea. Cheers and good luck on the build |
Quote:
So another question; Since making these connections have you tried filling the tank up by any chance or is the project still mid-build? I'm concerned that the fall to the tank won't be enough and as a result at each fuel fill-up the fuel will back up, causing the fuel-pump to cut out mid-fill. Something I'd like to avoid ultimately! :fear: Many thanks again! |
Quote:
I had the same concern so I have put 5 gallons of petrol through the filler as a test (and also to test for leaks prior to bonding on the rear body of the car) with no issues at full flow. |
Quote:
Many thanks and I look forward to other updates on your build too! |
Quote:
https://i.ibb.co/NxVxxWC/IMG-1383.jpg Take note of where I have cut out a notch in the body to make sure the pipe can lay as flat as possible. https://i.ibb.co/jf69rrH/IMG-1384.jpg https://i.ibb.co/SKgzK6W/IMG-1385.jpg Plenty of clearance with the body as it comes up to the 90. |
Great, thank you, that’s most helpful indeed!
|
All times are GMT +0. The time now is 04:54. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022