Steering wheel airbag
Hi guys
I am sure I read a thread on here about fitting a wooden steering wheel and fooling the airbag sensor with use of some resistors. I have searched and can’t find the thread😩 Mine in an early car with o e stage airbag. What resistance do I need to put in series between the two airbag wires Thanks |
You can also just pull the airbag sensor box from behind the centre console. Pictures from mine on here somewhere
|
Quote:
|
It's worth joining the Z Register for this sort of stuff as well.
|
Quote:
|
Hi Hugh,
3.3 ohm resistor for each squib that you need to isolate. I had a Two stage airbag so needed to go across the two circuits, two resistors. Check your wires coming out and trace to work out horn and airbag/s as appropriate. Hope this helps. Cheers. Oh and remember that faults in the SRS system will hard fault until reset by a scan tool. (Light will stay on even if picking up resistor until cleared) |
Quote:
|
You'll need air bag warning reset tool b800 cheap enough on eBay. I would put a fuse in line with resister.
|
Quote:
What size fuse would you use? Thanks |
Ah! Got me there lol I just bought pre built version off eBay which had a fuse as part of it. Just checked on eBay- it was a yellow sealed unit with 2 amp fuse. Fuse is there to Stop resistor blowing if the airbag is triggered
https://rover.ebay.com/rover/0/0/0?m...2F261532857253 |
Thanks for that link Smash! Just ordered one as well.
|
Here is a picture of mine when I was remodelling the centre console.
https://photos.app.goo.gl/wAjcsZRqrtzkY3mz7 https://photos.app.goo.gl/wAjcsZRqrtzkY3mz7 The airbag sensor box was about where the heater dial is in the picture |
All times are GMT +0. The time now is 19:15. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022