Todays Progress 9th April.
Decided to start off the day stripping some more loom down, managed to cut quite a lot out so far, still faaaaaaaaaaaaaaar too many wires there tho, also forgot to take pix of that :der:
Anyways, then i decided to make a start with some body bits: http://www.talkaudio.co.uk/gallery/d...0/IMG_4101.JPG There she is hanging so i can do all my cutting without damaging parts of the chassis. First job was do put the engine bay cover on, get it all aligned and then drill these 2 holes from underneath: http://www.talkaudio.co.uk/gallery/d...m/IMG_4102.JPG Next i decided id do some of the holes inside: http://www.talkaudio.co.uk/gallery/d...m/IMG_4103.JPG So there we have the fuel sender/pump access hole, handbrake holes and cable mounts, gearchange hole, just in front of that are 2 pipes for the heater, and then one for the steering pinion. Next i decided to do some cleaning, before shot: http://www.talkaudio.co.uk/gallery/d...m/IMG_4098.JPG After shot: http://www.talkaudio.co.uk/gallery/d...m/IMG_4100.JPG Amazing what difference a bit of elbow grease and biological washing poweder makes. Then i decided to start mocking up the brake pipes and clutch pipe http://www.talkaudio.co.uk/gallery/d...m/IMG_4107.JPG Also here you can see ive put the air con pipes through. Then the last bit of work for today, the rather careful task of cutting out the front air intake: http://www.talkaudio.co.uk/gallery/d...m/IMG_4108.JPG Its nearly there not quite, bit more sanding to do on the top left, decided i'll fabricate some brackets at a later stage that can hold some mesh in place at the same time as holding the front number plate. And thats it for today :thumb: |
Arrrh, fibreglass dust, breath it in...will stay with you forever :eusa_hand:
John |
All times are GMT +0. The time now is 21:19. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022