K20 Issues/Questions
Hi All,
I'm after a little help with some wiring. I am in the process of trying, at long last, to wire in my air-fuel ratio sensor but struggling with the diagrams and what wires go into what pins on the ecu etc. Does anyone have a simple way of explaining what wires from the sensor go to which pins/plugs on the ecu?s Secondly has anyone yet supercharged or tweaked their K20 and if so which way/products have been used? My car will be out on track shortly, now that I have the money to finish it off & all being well it will be raced next year. Jono |
Hi Jono,
I've got a wiring schematic for the install I did. Feel free to drop me a PM with your email address and I'll send it over, but for starters the O2 wiring is: Black/Orange = Heater Power. Connect to switched 12V Black/White = Heater control. Connect to engine harness pin 10 White = signal plus. Connect to engine harness pin 19. Pink = signal minus. Connect to ECU "E" connector pin 4. Don't forget to earth the shields. Good luck! Richard |
Hi Richard,
Thanks for the info, I think I understand it :) info@JONORacing.co.uk is my e-mail Cheers Jono |
All times are GMT +0. The time now is 17:22. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022