Fuel Regulator - Type R
What fuel regulator have builders used for their Type R engines?
I'm assuming that it's got to work with injection pressures (higher than carbs) and have a return (to take fuel back to the tank). I already have a separate pressure guage, so don't need that built into the regulator. Any help, especially make/model/supplier would be greatly appreciated. Thanks in advance. |
I'm using an FSE fuel pressure regulator, set (I think) to 47 psi (static - no manifold tapping).
Fuel system goes: Rover tank pump (8mm pipe) -> swirl pot -> walbro 255 -> filter -> t-piece (with 8mm tapping to fuel rail) -> fse regulator -> swirl pot (6mm from reg to swirl) -> tank. Fse reg is approx 300mm from fuel rail, to ensure the displayed pressure is as close as possible to that seen at the injectors. Some people I believe have placed the regulator and gauge near the fuel tank, which seems daft - it's best to regulate as close to the point of use as possible. |
Thanks - that's good info.
Did you getthe regulator from Marlin? I don't suppose you know the model number off hand? Thanks again. |
|
All times are GMT +0. The time now is 10:30. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022