Dash lower edge radius
Has any one any pictures of how they achieved the lower rash radius? Struggling to work out how to do it on my dash!
|
My dash was a 2mm ali sheet. I just used a simple push fit u shapped rubber section from Wollies asI recall. Covered it in leather cloth and it looks fine.
Cheers Robin |
Thanks for the reply, I ended up getting one of our carpenters at work to put a 20mm radius on either side of a wooden batten which I will then fix to the lower straight edge of the dash to curve it round nicely, then foam and leather over the top
|
I used a section of 1/2 inch water pipe lagging and covered it in leathercloth.
|
Here's how I did it
https://farm8.staticflickr.com/7399/...6bb08e73_b.jpg https://www.flickr.com/photos/580680...7631927211957/ I just used a suitably radiused piece of wood trim that was then covered in foam and vinyl. I was caught out on the area behind the wheel though so ended up gluing a sliced piece of silicone hose over that and then stretching the foam and vinyl back over the top. |
All times are GMT +0. The time now is 13:49. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022