26th June 2022, 13:30
|
Senior Member
|
|
Join Date: Nov 2012
Posts: 845
|
|
Low tech, picture of prints!
I found the picture mentioned above, as well as the one I took at TDW's place. In the background can be seen a completed Sierra, a Melos and another Phaeton, both awaiting pick-up.
This is the bolt on frame I fabricated to locate the bottom seat belt mountings. It was 1.5" steel angle welded together. The LH holes (as you look at it) coincided with the gearbox mounting, the centre ones bolted to a cross member, and the RH four are for the belts. I'll definitely do the same again.
Regards, Mick
|