Personally I wouldn't want to make the roll bar cutouts myself. The material has to be reinforced by being doubled up and stitched - not really a DIY job. I spoke directly to the manufacturer and they said to send it back directly to them - which I have done. It will be interesting to see the results....
When I spoke to Lang & Potter (who make the Tonneau) they told me that they had the pattern for the cutouts - but their seemed to be some confusion between them and Marlin as to if they were standard.
Hmmmm.......
Robin
PS - I beleive that there is a tool that you can buy to fit the bits to the tonneaue - but it is expensive.
|