Quote:
Originally Posted by NigelB
Hi Mike,
My worry has been the need to create a 19mm radius on the bottom edge to meet IVA requirements. How are you planning to overcome that. Have you got a seperate IVA dashboard as a tempoary fit..............!!
Nigel
|
The IVA manual says...(and was very similar on the old SVA)
7. The instrument panel lower edge within the “specified zone” must have a
radius of curvature not less than 19mm or 5mm and covered with a nonrigid material.
I used some soft rubber 'u' channel stuck to the bottom edge.
Passenger foot well by
marlinpeter, on Flickr
But I guess this might not look to pretty on a wooden dashboard?