Gary ...we cut a hockey stick from 6mm ply by using the body bulkhead as a template....hold the ply against the bulkhead and draw a line from top of bulkhead to bottom , this gives you the curve ...draw a parallel line about 3'' in to give you the section.
This then fits inside the bonnet as shown and should keep your lower wing at the right profile to match the bulkhead....hold it in place with a little body filler , hot glue gun , sikkoflex etc. and then glass fibre both sides ...we wrapped it totally but you won't do it in one go , glass both sides and just fold about an inch over the top both times....this will then be sanded to remove splinters before paint.
|