Made reasonable progress this eve. Cut the new boot lip down to size, and filled and faired it. Trial fitted the old seal, then trimmed up the boot lid and inner moulding. Put them ib position the added a couple of self tappers through the two so I can glass them together in exactly the right place.
As the body was off filled and faired the vents behind the door pillar. They will be seen from the inside so have filled over the grp and faired it in.
A bit mire work to the rear vents, doubling the thickness of the cut edge ti make look mire substantial.
Finally did a bit of tweaking to the l.h. door shut so it will match my chosen seal.
[IMG]
[/IMG]