[woodsmith]

Been a while since I was last well enough to work on my projects but hopefully back again now.

I am trying to figure out where to get a windscreen from to develop a cockpit around.

I am after something from a commonly available car or kit, not too expensive to get new/used, laminated to meet MSVA requirements. I guess that's usual for most of us anyway.

However, this is the long shot! I am after one that is only about 900mm - 1100mm wide (about 36"-44"), give or take a bit. I am really trying to keep the overall width of the cab a lot less then 1200mm (48").
The height is less of an issue but taller would be better.

Thank you.