To gauge the height of one side, applied filler to area, covered in a sheet of plastic, compressed form.
Headed towards lines at base.
Biro/ink lines can be found/picked up, through the filler.
Almost there for back section...
During this period of being in limbo, managed to continue with plug fabrication, although on our GS:
http://www.bikechatforums.com/viewtopic.php?t=263785
Plugs fabricated in similar fashion, although used Carbon fiber/ Kevlar and Epoxy to fabricate panels.
Did purchase some beautifully made epoxy doors.
Strengthening of the chassis was a priority, so was going to GRP half doors, then fabricate door to fit, but figured...who needs doors.
Our re location looks like its going ahead, within couple of months.
Itching to get on with things.
Looks like most of the metal bodywork is gonna be junked.
Will take some copies, or molds from rear wings, and get to work.
Would like to move engine rear wards, CF/ Epoxy floor, and panels.
If theres any progress in future, I'll be sure to share.
All the very best.