Quote:
Originally Posted by WorldClassAccident
WCA, can you lower the rear end a bit? - Already scraping the exhausts on the bumps, perhaps bigger tyres?
access to the back of the holes - No real access as it is basically a box girsder. I can poke sticky tape through the holes and try to get it to stick but that is about as good as it gets.
P40 - If I get the tape stuck to the back of the holes and then fill with P40 is there much likelyhood of the P40 shrinking back or working loose over time?
rivet a piece of thin Ally - Possible but I would prefer to simply fill the holes rather than cladding it and then trying to blend the edges and hoping the panel doesn't work loose.
|
I would have thought the ally skin would be the easist. Personally I would go to a local sheet metalworker and get them to make up a simple sheet with a return lip at the bottom edge. I would then glue it on with something like tiger seal (it will never come off).
Mucking about with all those holes filling and flattening sounds hard work.