Pulled this quote from my previous entry on the EBay SWB tread:
Quote:
Originally Posted by TributeAutomotive
First priority is to pull a couple of splash moulds off the front and rear of the buck (after a lot of remedial work) to finish Geoff's Z3 based car. After Stoneleigh we will look at moulding the whole buck, but will confirm availability of shells once this has been done.
|
The obvious, and the only viable route for us as Tribute Automotive, is a non-IVA body swap onto an existing chassis that has the correct wheelbase, the TVR Tasmin 'wedge" fits the bill on both accounts. The only downside with this
potential new project is the huge amount of labour (unpaid) and investment (£) needed. We need to make this a viable proposition before we can proceed any further.