Oh, just saw your post Nick, glad you like it, but anyway i will be keeping the wide arches. Kind of like them so i fitted spacers instead. Later i will widen the rear wheels about 2,5-3 inches inwards. But i will have to rubb these tyres out first!
Ok Jones! Your absolutely right, i have to post some updates, been very busy with other stuff too, but "all" that stuff is sorted out now. So here they come!
Thanks and best regards from Andreas in Sweden!
Rear wheels fitted with 38mm hubcentric spacers!
Have had the body bonded on to the car permanently. Also cut away the tailpanel from the miata and deleted the hatchbox as i´ll be using DZUS fasteners
Lid is on
Extended the area against the screen as i got a bit wild with the anglegrinder earlier....
Raw finished
Some DZUS catches for the flip
Theese locates the flip lower rear parts so it always lines up when closed. Goes over pins
Also cut the wheel openings to get them symmetric, and molded new inward edges
As it will be seeing some trackdays i made a rollcage. Bolted to the chassie
Theese very nice racing seats Chris made for me, they are very light and solid, about 3,5 kilo each. Saves up a lot of weight compared to stock ones. Made some brackets to fit them to stock mounting points. Chris has the moulds to the seats