Quote:
Originally Posted by Kit 275GTB
I don't want to hijack this thread but I have been following it for some time and value the informed opinions I have read. I have posted a new thread in the "Italian Replicas" section where you can see photos of my thoughts so far but my big question at the moment is - do you have any ideas for matching the Z3 door window shape to the shell of the 275GTB? The rear of the Z3 window is upright and has a rounded edge to match the hood but the 275 is strongly angled back and I need to fill the gap somehow. Thanks for your help.
|
Check 'Geoff's 250 SWB Replica Build' thread on the Tribute forum for a discussion around the same issue.
The short version is that the simplest and most cost effective solution is to go for a two-piece sliding perspex arrangement as per an awful lot of period race cars -
Good luck with your 275 project, the Z3 does appear to be a cheap, plentiful and versatile modern donor.