Well here we go again, it's time for...
Filling, sanding, filling, sanding, filling, sanding, filling, sanding.......
And while this time I'm not going to have the bonnet problems i had with my Sammio
i do get to experience the fun of hanging and gapping doors for the first time!
Hopefully i should break the back of this over the weekend (famous last words?), although before i go too far i do need to do some measurements on chassis height because if with the existing setup the chassis is currently level, then I'm going to cut and lower the rear arches to address the gap. But if the chassis is currently higher at the back then I'm going to get an extra lowering block to bring the back end down and leave the body alone.
funfunfun