Quote:
Originally Posted by Dpaz
Hi Paul
I would have thought that the Midge would have been a bit small for an Alvis chassis. I would start from scratch. Put a board on the chassis ,put seat on board, move seat and steering until you can reach the pedals and gear lever. Build car around those measurements. Simples! I have some plans somewhere in here, if I can find them. Give me a shout, Dave.
|
Dave
Yes and No ?
Well I was interested in what sizes of timber was used and the general method of construction rather than doing a direct copy of it.
I now have the build instructions for the MK1 but no paper templates.
However the Alvis is probably not a suitable basis for this project and so will be sold when the V5C gets back.
regards Paul