Tuesday - Part 3:
By now the filler had set hard enough to be sanded down.
And all the low spots will be getting some extra fibreglass matting at some point.
Next I offered up the off cut from the body shell extension piece.
A quick bit of trimming later and I had a better fit.
I was still left with a big gap at the rear edge of the bonnet.
So I cut a piece out of my "left overs" pile to fit.
Before fixing the two pieces into place like so.
So you can see I am slowly closing the gap from bonnet to body shell.
I know this is a painfully slow process, but I am getting there.
Last job for the night was to finish cleaning the drive.
That's all for today, so until next time, take care, Paul.