Not the best of days working on the car...
Decided to tackle the dash.
Made a beautiful template and measured everything up perfectly. Checked, rechecked and checked again.
Then carefully cut 4 holes perfectly into the dash. Holesaw was slightly smaller than needed but decided I could file it out to right size.
Same again for the big dials. This time hole saw was perfect size. Two beautiful holes cut...
Offered up the Speedo to check and it fell through. Vibrations had made hole too big. Shit.
Checked smaller holes and they fit perfect. Decided to trial fit gauges to check. Oil temp, oil pressure, water temp, fuel and bollox, the clock. 5 dials. 4 holes.
|