Quote:
Originally Posted by 8 Valve Ed
At least it's on the 'heel' of the mount rather than the 'toe', you can, to could buy tapered washers to use with rolled steel Joists (RSJ's) to accommodate the taper of the flanges, not beyond the scope of an angle grinder to make some from thick washers.
Looking good! You need a little good luck from time to time.
|
Yes, I did find some of those 'I-Beam' tapered washers on ebay but like you thought I'd have a bash at making some, so I have ordered some thick square washers.
The material around the bolt hole in the mounts is are about 10 mm thick so I may just take a bit off the 'heel'