Thank you Dave!
The wheels are Ultralite in 18 inch diameter with an offset of 30 to try and fill the arches as much as possible.
The lights have been mounted in the body using 3mm acrylic pipe for the shape and then fibre glassed in the rear to keep them secure.
The acrylic tubes got cut down to match the curves of the body when the hole for the number plate recess was cut out.
The rear had to be taken off again to run the fuel filler extension up the inside of the bodywork to the rear wing.
After a bit of testing the wiring in the old tail light the new lights were in and working...
Then another few photos after I had mounted the number plate recess and sanded the mould lines on the front of the car.
