re-lamps
also these lights +covers fit inside the hole in the front panal i would get correct lights those 3000s you have shown in your pic look too big they should fit inside the hole with covers flush with the front i made some brackets that run down the back top to bottomspanning the hole bolted thru f/glass with a tab coming forward to pick up on lamp bracket at the bottom you can then adjust them up- down +left to right using the original lamp bracket it needs a slot cutting i f/glass at bottom front edge to let the tab on the lamp at the bottom sit back you can just see this in last pic (above) i made the cut out about 4mm wider than lug on lamp each side hope this helps mick
|