Thread: Z3GTc New Build
View Single Post
  #22  
Old 9th July 2020, 19:34
Lucky@LeMans Lucky@LeMans is offline
Senior Member
 
Join Date: Aug 2012
Posts: 1,640
Lucky@LeMans is on a distinguished road
Default

I've progressed the car a little, still waiting on the rear end and boot lid so I can get the car finished.

The under bonnet wiring has been cut back and thinned out ready to be fitted and extended where required. I've gone with black "stone chip" finish on the under side of the bonnet. This is the Hammerite stone chip, the only product they make that I actually like and would recommend ! Not to be confused with Hammerite underseal which is crap !!
In the bonnet photo you can see I've fitted cable tie pads to secure the wiring. I scraped off the double sided tape backing ( which dries out causing the pads fall off ) and attached them with PU adhesive.

That's about it until the rear end turns up. I might remake the door cards for a more retro look and I need to order a nice wood rim steering wheel, probably a good time to get the wheels freshly powder coated too.

Last edited by Lucky@LeMans; 9th July 2020 at 22:22..
Reply With Quote