Ready to start - but some parts needed
Hi folks
just had confirmation my body is almost ready, I unfortunately can't collect until the back end of the month, but hey ho!! what can ya do!!
Anyhow, I'm on the look out for some parts for my donor and was wondering if anyone can help.
I bought my donor as a reconditioned and painted chassis, engine and front bulkhead (all the bits I need), but with a Poor (with a capital P) body.
I am getting rid of the body this week, but on further examination I am missing a few essential bits.
I need :-
2 front calipers (type 14)
clutch and brake master cylinders inc. brackets and linkages etc.
accelerator pedal and linkage and cable
Handbrake mechanism (however do have a full sierra handbrake mechanism which I will try to modify)
Clutch slave cylinder
A set of clocks, (can get a cheap herald speedo but would love to fit a rev counter)
A swing spring and uprated front anti roll bar
and I need to sort some decent sized wheels, open to ideas but am unlikely to be able to afford wire wheels just yet.
Hope someone can help, I will be starting a build blog as soon as my hols are over and I have my body from Gary
See ya later
Alan
|