Time to start on the lights. Exciting bit, as by now, I am tired of filling/sanding, and need to recharge my enthusiasm
Wiring the lights into the original BMW Z3 wiring loom may sound a little daunting to some. All I used was a multi meter and tested each pin of the original connector block, when switching the lights on/off, or pressing the brake pedal. Once I saw 12v on the meter, I knew I had the right wire and connected them to the new lights, using heat shrink or
waterproof connector blocks.
My advice to any other new builders is to carefully plan this stage; double check all your connections before you make any cuts, sketch out a diagram if it helps (I did), and consider whether the item you are connecting will need to be removed at a later stage of the build or operation.
