Quote:
Originally Posted by 8 Valve Ed
I very rarely set out to write a long post! I much prefer a single liner...
|
However... More often than not I find myself glued to the keyboard expounding on some topic or other because my enthusiasm gets the better of me.
I have never resorted to using a separate software to create the text for pasting into a forum, way too much of a faf. By far the easiest is to copy the text to the pasteboard and have it there in case things go pear shaped when posted, but this is the first time I have had an issue on this forum in about a year and a half, so I wasn't prepared for a loss of text.
Anyway getting back on topic!
I have fabricated a little pipework to replace the kinked rubber pipe which was plugging the heater pipe outlets at the back of the inlet manifold. A kind neighbour has found me a piece of 90mm 316 stainless tube which will act as an expansion tank.
With luck tomorrow I hope to do a little TIG welding to refresh my skills and try out my new bottle of gas.