Thanks Wozzy for the tip about adhesion aid - seems to have done the trick on the off cut of macron/Perspex when I tried it over the weekend so will give it a go on the windows this week.
Another question for fellow MRS200 builders....how did you fix your mesh grilles for the ear scoops? I’ve bolted the rear clam vent grilles in and was planning on using Tigerseal to bond the mesh from the back. This looks like it should work on the vents in the front bumper but there’s not a lot of surface area to bond to in the ear scoops.
I’ve used this method before on other kits where I used wire and a piece of thin wood to hold the grille in place from the front of the panel whilst the tigerseal set, just not sure it will hold on the scoops.
Any thoughts?
Thanks
|