Hi Finished the Diff to chassis tie bars, these were made from a tractor pin flange and CDS tube. The tie bars run both forward at an angle and to the side at an angle there by giving an anti twist bracing. That way the top 4 Diff bolts do not take all the side and to/fro load especially under power.
Next to finish the brake hose connections and put on a diff base tie plate, these will simply be 2 lengths of flat bar 40mm wide and 5mm thick, these run side to side on the diff base.
Then onto the radius rods from the bottom dog bone arms to the chassis again these will stop the arms trying to walk under power load.
Anyway here's some more pics.
http://s1342.photobucket.com/user/Ba...%20install%206