Third thoughts
After an observation by Egdik that the front edge of the side window of the Z3 seemed to be angled back about the same amount as the rear edge of the 275, I realised that I could possibly make a replacement glass (or plastic?) window that would wind up and down. So back to the paper cutouts again.
This time I have moved the rear part of the 275 forwards so that the bottom of the glass meets the Z3 window and cut a new wheel arch further back.
I have made the sill one part with the lower front wing where the gills sit and managed to preserve all four while moving the wheel arch back. The top half of the wing will open with the bonnet like the Z3.
I still haven't quite resolved the door opening.
What do you think?
|