View Single Post
Old 26th June 2019, 16:36
GaryR GaryR is offline
Join Date: May 2019
Location: Ascot, Berks
Posts: 51
GaryR is on a distinguished road

This afternoon and working together we offered the metal strengthening cage into position in order to mark out and drill the rear fixing stud holes through the inner rear wings to the boot. Easier said than done as the main tubes slide down inside the Z3 roll-hoop tubes but are an extremely tight fit!

Half an hour and several hundred thwacks with a soft-faced hammer later....
After which of course we had the fun of removing it again

The rear left hinge in the picture is going to need to move if we're going to be successful in fitting the filler where I intend in the rear deck. Ian tends to get these cages fully prepped and powder coated before fitting too so it'll look a lot different further down the line!

Last edited by GaryR; 26th June 2019 at 16:40..
Reply With Quote