Quote:
Originally Posted by Ace
Hey Gary, I appreciate it! Its slow but steady progress.
I can take some pictures showing what I have done, but I found a good route where the filler line is level and does not have any petrol sitting in the line after fill up.
You run a 90 degree bend out of the tank connection and connect that up to a flexible fuel filler hose. I ran that over the arch of the wheel and then put another 90 degree bend that runs into the boot area. Then you have to run a solid 37" piece of 2" pipe across the top of the boot area where you can 90 into the fuel filler cap. That probably doesn't make sense, but I will take some pictures this evening and share them to give you an idea.
Cheers and good luck on the build
|
OK, interesting and many thanks! I think I understand you (although pics would be most useful too please if you'd be kind enough when you have a mo!).
So another question; Since making these connections have you tried filling the tank up by any chance or is the project still mid-build?
I'm concerned that the fall to the tank won't be enough and as a result at each fuel fill-up the fuel will back up, causing the fuel-pump to cut out mid-fill. Something I'd like to avoid ultimately!
Many thanks again!