I have managed to get some time in on the A352 I tidied up the wiring in the boot and now have the option of reversing, rear and front fog lights I don't know if I'll fit them yet as not required by law and may not look authentic.
I have also taken off the engine bay panels to get at the suspension to lower the front springs, a bit fiddly as it is trial and error to get it right,
cut out 1 coil flatten it down grind a flat seat re fit lower the car check1 probably wrong so start all over doh again
so if you cut 1 coil off and it lowers the spring say 1" when extended how much is it lowered when compressed?
Also anyone know if the prop shaft flange is the same size on both the early and the later Diffs? I know the drive shaft flanges are different but what about the prop?????