Thread
:
Just another MX250 build! (Pic heavy!)
View Single Post
#
47
23rd April 2020, 07:39
TynoPrime
Member
Join Date: Aug 2014
Posts: 66
Having looked around at the engine bay there was lots of spots of rust, especially under the brake master, where there had clearly been a brake fluid leak at some point and the DOT3 had eaten through the paint and started on the steel.
So I pulled everything else that was in the way, and got the engine ready for paint. Again, I didn't want to drop out the trans/engine so i went as far as I could to allow the space to paint the engine bay.
After cleaning back i then treated all rust with a rust converter before priming over it
Last edited by TynoPrime; 23rd April 2020 at
07:41
..
TynoPrime
View Public Profile
Find all posts by TynoPrime