Mr T, I am going to use the standard 3-point belts (due to current budget constraints) and so will use the top one that Gary has already welded on, and then I have added the two lower ones on like the photos below.
My chassis is a 1964 Mk1 so it does not have the inner seat belt mounts so I have had to make some up with 50mmx5mm flat bar. I will weld nuts on the back of them before the body goes on, so the belts can all be removed from the inside with a single spanner. Another factor was that I wanted to have a tonneau cover so I didn't want them above the cockpit line like Davecymru's (although I do like the look of them!)
IMG_0878x450.jpg
IMG_0879x450.jpg