Molleur, Jones, Dave, Mr T & Colin - Thanks gents.
Note: If there is any drumming from the panels I have plenty of screws left over.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Just a token gesture...
While the seats are still out, I thought I should test fit the base panel for the hand brake gaitor.
Then I just rested a seat in place and realised it would be easier to drill the fixing holes now.
After a bit of trimming and hammering I was left with this.
Eventually, I will use the same 'access panel' screws to fix this in place.
But for now, I just used some screws to hold panel in place as I drilled holes on each side.
This panel will be scuffed before final fitment, as this looks way too shiny.
Other odd jobs today included using some Kurust on the seat spacers.
Plus I masked off the areas around the new mirror bolt access panels.
At some point, the underside edges will get a coat of Tetroseal.
But that was all for today, cheers, Paul.
