Ordered a few sets of chrome wires, bit nerve racking as its a lot of money if they don't fit. However fears were unfounded as they fit really well. Centre lock hubs with a peg type drive, much better than the old style splines, triple eared spinners are the finishing touch.
Yyres 205/65x15 and the suspension lowered by 30mm. Lowing the suspension causes the top of the wheel to tip in slightly at the top. I was of course allowing for this otherwise it might have been a bit tight
and they also fit
Next job is the dash which I'm really not looking forward too but all mocked up on the bench
