Hi Lumpy, will try to get fresh pics of it as soon as i get the chance but the dark evenings may stop me from getting any til the weekend now.
I just attached the grill using polyeurethane adhesive (tiger seal is the same stuff I think) just held the mesh in place with tape and then used blobs of the adhesive every 10-15 cm around the parameter. If I every need to remove the grill it should pull off without breaking the mesh but I shouldn't ever have to take it off.
I toyed with the idea of sticking in threaded rods and using washers and bolts to hold in the mesh but was just getting too complicated to get the all in place and measured correctly.
|