I have welded up a basic frame , the floor sections were done a few weeks back , but added the tubes this week ...its a perimeter frame only so far ..no hinge mounts , tank mounts etc....
I have clamped a body roughly in place but won't fix it until I have the wheels on ...the car currently has an odd , tiny wheel on the rear passenger side with more inset than stock ...its throwing all the measurements out , when trying to line the body up on the arches etc.... All frame measurements were taken from the stock Scimitar chassis - and even they aren't 100% accurate from the factory !
Following pic shows plenty of clearance on a V6 in a Scimitar chassis when the engine is moved back a few inches ...
