Not a lot to report made two indicator stalks out of stainless and two out of ally, the stainless stalks have a push switch for a horn or washer pump facility where as the ally stalks are solid, will wait and see which ones i will use.
I am thinking along the lines of shortening the original stalks and sliding the new ally ones onto the old stalks, may be glue with araldite or if i use the stainless stalks i will have to cut the old stalk off completely and attach the small plate to the indicator switch body which will be fun!!
IMG_4297.jpg IMG_4298.jpg
The small push switch is behind the spring, machined a slot in the moving end to locate a nylon covered pin. The ally stalks are one piece with a 5mm dia x 50mm hole in one end to fit over the original triumph stalk.
The chassis is off to be shot blasted on Saturday so once back i can begin to replace the suspension parts etc and start to see something happening. Hopefully off to Stoneleigh this weekend to pick up a few goodies and see the Ribble guys.
See you all soon.