Spot The Difference:
Limited car time (again), but still managed to get a bit more work done, although you'd hardly notice the progress.
Removed the various bits of tape from the cockpit side lips and sanded the areas down before adding some fibreglass filler.
( Both inside & out. )
I also applied some fibreglass filler along the bottom join of the boot floor to body shell panelling.
Cut out some more fibreglass matting.
Which formed part of the final round of fibreglass matting along the top join.
That is definitely it as far as this side of the panelling is concerned.
So at some point this will all be sanded down and painted.
Last job for the day was to sand down the filler along the cockpit side lips.
So that is now ready for a layer of fibreglass matting along the "gaps" on the outside edges where the tape was.
Hopefully, this will look a lot better by the time I've finished tidying it all up.
Until next time, take care, Paul.