Not much achieved today as I had my son to look after this morning and had some parts chasing to do ...
I have now got this section ...
I'm fitting the filler cap in the 250 GTO location , which has me a little perplexed at the moment trying to find a solution to the new placement and the route the fill tube can take to enter the tank nicely , no kinks , not too slow a fill etc...I've got a rough idea how its going to work but until I start digging , not totally sure ...
The boot corner piece Chris at Tribute supplied is a good starting point , the cap needs to be recessed slightly , reducing the flow angle , but I think we can make it happen ...
I finished the hinge movement earlier , rebraced it and checked for operation ...so not much achieved today , hoping to get a few hours on it tomorrow as I only have a certain amount of time to get this car ready for the paintshop ...
