chassis
Hi
The centre section still requires a centre tunnel building and also cross bracing for the mounting of seats.The two cross pieces of timber and the diagonal piece seen here are spacers and a cross tie bar to keep the frame square.
Also where the front frame fixes there will be another frame to take the dash/steering mount and door hinges, but I'll leave this until the shell is on.
Front and rear crash structures will be designed to support the front of the car and mount the front rad and bumpers,the rear being used to support the boot floor and rear bumpers. My plan was to have these bolt on.
I intend to have 75 x40mm and 40x40mm box section steel tube.
ian
|