Jack and Froggy, cheers for the feedback.
------------------------------------------------------------------------------
With the nearside wings in place I could crack on with the front lights wiring. To meet the IVA requirements I needed to securely fix the wiring under the wings. To fix to the GRP wings I made up these pads......... I pop riveted these special cable ties to 4cm square pieces of aluminium. (I've had a packet of these cable ties in my box for years and never found a use before.)
Cable tie mounts by
Sabrebuilder, on Flickr
I then glued the cable tie mounts to the front wing with a good dollop of PU adhesive. This time I remembered to remove the black schultz coating and I roughened the surface with some sandpaper.
Wiring pads by
Sabrebuilder, on Flickr
I also bolted a cable tie mount to the side of the headlight shell.
Headlight wiring by
Sabrebuilder, on Flickr
After painting the support pads and surrounding areas, i have completed the headlight and front indicator wiring.
Headlight and indicator wiring by
Sabrebuilder, on Flickr
The side light wiring runs along the upper wing support.
Side light wiring by
Sabrebuilder, on Flickr
..and the side repeater wiring runs along the lower wing support.
Side repeater wiring by
Sabrebuilder, on Flickr
Now I need to do the same on the offside.......
.........peter