A few photos of the work I've done over the last week or so.
The curved box formers have made easy work of the bonnet return edges.
The scuttle panel along with the roughly formed bonnet edges sitting in place. A bit more work needed on these parts before final fit !
The engine has been in and out a few times, next time it goes in should be the last.
The interior is stripped back to bare bones and cleaned up. Also welded up all the holes along the top chassis rail where the old Locost body was rivetted on.
Last edited by Lucky@LeMans; 7th September 2018 at 17:06..
|