Thread: 'Carbon' filler
View Single Post
Old 7th August 2020, 17:38
Mister Towed's Avatar
Mister Towed Mister Towed is offline
Senior Member
Join Date: Jul 2011
Posts: 5,196
Mister Towed is on a distinguished road

My best guess is that chopped horse hair in ordinary polyester filler would do the same job as either carbon or csm strands. It's just something to hold the filler together and stop it cracking when you bridge gaps.

I'm sure in a lot of these car restoration shows, the star mechanic probably could do a good job given enough time, but instead picks up a sander, reads off the auto-cue "I'm just going to flat down the bodywork with this random orbital sander and some 800 grit wet and dry discs." does a couple of shots to camera wielding the sander while wearing a dust mask, then buggers off back to their trailer while some flunkies spend a week doing it properly.

There are too many occasions in those shows where they make it look like fabricating and welding in new panels is a five minute job.

Oh, sorry to go off on a tangent, to answer your actual question I haven't tried carbon fibre filler but the csm stuff does the job even if it is a bit of a pain to use as it doesn't spread as smoothly as standard filler (that's a massive understatement).

Last edited by Mister Towed; 7th August 2020 at 17:40..
Reply With Quote