View Single Post
Old 19th February 2010, 08:11
nutter's Avatar
nutter nutter is offline
Senior Member
Join Date: May 2009
Location: Hampshire
Posts: 147
nutter is on a distinguished road

Whilst your on this subject this seems relevant to post here

My new build uses the Rear bearing from Rover, with a VAG drive plate.

If your doing a new build with a VAG donor, the VAG drive plate needs machining down a little to fit with the new rear upright.
The spindle needs a little skimming of it (in the region of 0.5 mm) and the plate itself needs thinning so that alignment of the calipers is correct.

Contact Marlin if you need the mod doing.


Last edited by nutter; 19th February 2010 at 08:19..
Reply With Quote