View Single Post
  #20  
Old 6th May 2010, 20:33
alackofspeed's Avatar
alackofspeed alackofspeed is offline
Senior Member
Enthusiast
 
Join Date: Jul 2005
Location: Dorset
Posts: 1,180
alackofspeed is on a distinguished road
Default

Craig, they'll fit, but the outer radius of the pads will be at least 10mm from the edge of an almera disc, in fact it's probably more, as the 240mm caliper has quite a section of pad that doesn't contact the disc.

Is there any way you could create some mounting holes nearer the axle, to enable the 260mm caliper to fit, and the pad fully contact the disc?

As an aside, the piston on the 240mm caliper is smaller than on the 260mm, so your brake bias will move forward with the 240mm caliper.
Reply With Quote