View Single Post
  #296  
Old 20th December 2017, 22:30
peterux's Avatar
peterux peterux is offline
Senior Member
Enthusiast
 
Join Date: Mar 2005
Posts: 2,883
peterux is on a distinguished road
Default Every little helps.....

With a combination of the very cold weather and the Christmas preparations now in full swing, I've had little time to do any major work on the Sabre.

Grabbing the odd 1/2 hour here and there, I decide to dig out the Sabre's wiring loom and started to check it over and label it properly. The original builder's hand written labels on masking tape (that is now over 22 years old!) are all but unreadable. The wiring section of the build manual has the cable's colour codes so its a case of identifying which cable is which and then sticking a label on it.
I'm still a long way off installing the loom but it is a job that I can do as and when time allows. It should make the installation of the loom much faster when the time comes.

The Sabre's main loom has a number of subsections separated by large multi plugs.
I started with the dashboard subsection....

Dashboard wiring loom by Sabrebuilder, on Flickr

I have a small Brother labelling machine that works really well and is highly recommended.

Next up will be the sub-loom that goes to the back of the car for lights and fuel pump, etc.


....peter
Reply With Quote